LED Turn Signal Flasher

Here is a great solution for all LED turn signal flashing problems.

 

• This electronic turn signal flasher will flash any combination of LED and incandescent light/s from one diode to a 20 amp load.
• Solves fast flashing and non flashing LED turn signal problems.
• Operates on 8 to 16 volts DC.
• In many applications this is a plug and play replacement for the stock thermal signal flasher. See important note below.
• Fits both 2 or 3 prong sockets.
• Load resistor and relays are not needed with this flasher.

 

CLICK HERE for a LED turn signal wiring diagram

If you're adding turn signals to a vehicle that does not have signals this is the flasher you need. Perfect for 4 wheelers, golf carts, street rods, sand rails, etc.

 

IMPORTANT NOTE! PLEASE READ!

• This flasher must be properly grounded or it will not work.
  The 3rd pin on this flasher is the flasher ground pin. This pin must be connected to the vehicle ground.

• The standard 3 pin socket used in most vehicles will connect this pin to vehicle ground, or you can use the black wire provided to connect to the 3rd flasher pin to the vehicle ground.

• The 3rd pin may be bent over if needed for a proper fit in your application.

• The black ground wire included with the flasher is used to connect the flasher ground pin to vehicle ground when used in a 2 pin socket application.

• If necessary consult your vehicle wiring diagram or use a multimeter to determine the pin configuration of the socket in your vehicle.